[Jewelry making - Article 00538] - Re: [Orchid] Setting cutting seats

[Gerald]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    hi folks! If you look in the April issue of the AJM all of you here
    will see my little invention on setting Cabochon stones in bezels.
    Its so easy to make why hasn't anyone else made this??/dunno. Its
    made with a very large round bur about 033 - 045+ size and go to your
    bench grinder and remove the top half of that large. You can now cut
    down to the most widest point of that bur, and voila, Cab-Cutting
    bur!!!! (its copyrighted !) Even Martha Stewart hasn't though of
    this..::>)  she's busy right now..LOL ! Invert this new bur and cut
    away to your 'hearts delight'. The flat cut side of the bur is NOW
    RESTING on the bezel's lower edge for the stone to sit on!!! Also now
    with this bur, you have made an angle for the Cab to rest
    'against'.... inside... the wall. I have about 12 different sizes to
    accommodate different sizes of Cab's...Gerry!


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________