[Jewelry making - Article 00403] - [Orchid] Ultrasonic cleaner and damage to aluminum foil

[Noel Yovovich]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    After reading that an ultrasonic should make holes in aluminum foil,
    I tried putting foil into the little unit we have where I teach (It
    says "Ultronic" on it, which makes me suspicious). It didn't do
    anything vivible to the foil, though it does get buffing compound
    and general grime off of things. It has not gotten all the junk out
    of the piercings and behind the half-point diamonds in my Tom Herman
    ring.                   

    So, do you think this is not really an ultrasonic unit? 

Noel


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________