[Jewelry making - Article 00072] - Re: [Orchid] Refinishing of steel surface plate tool

[kevdan]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    I have used muriatic acid to remove rust from tools it only eats the
    rust not the good metal after that you could use your flexshaft and
    rubber wheels to smooth out any pits or grinding wheels and then
    rubber wheels. I have a whole machine shop and make most of my own
    forming tools and hammers if I can be of any help let me know. 

sincerely Kevin Potter


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________