[Jewelry making - Article 00030] - [Orchid] Refinishing of steel surface plate tool

[Codchild]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Hi all: I am new to this forum and very excited to be here.  I am
    sure I will pick up many tips from all of you. I have been away from
    my workshop for many years and have now set it up again to get back
    into making pewter hollowware and silver/gold jewelry, etc.  In the
    process of unpacking my tools I cam across one of my surface plate
    type tools with round and angular indentations pitted and rusted.  I
    would like to get it resurfaced but have no idea where to bring it. 
    I have contact local machine shops but they do not have the small
    tools to get inside the round depressions to refinish and polish the
    surface.  I am hoping I can salvage this tool.  I will accept any
    suggestions.  Thank you. Pat in MA


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________