[Jewelry making - Article 01053] - Re: [Orchid] Half Donut Shape

[Paul Townsend]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


>        Decide on the outside diameter of the donut and make a 1/2
>     sphere conforming to this dimension.  Make sure you drill a small
>     hole in the centre of the disc before doming.  

    David I am assuming the size of the hole will dictate how big the
    hole ends up in the middle of the donut... 

    Can this be done using a leather sandbag as I do not have any pitch?
    Thanks to everyone for the help...once again Orchid rules


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________