[Jewelry making - Article 00885] - Re: [Orchid] Tools organization ideas

[Gerald]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    For my diamond setting bench, I use plastic peg-boards. They are darn
    cheap about $12.50+tax each, for this price I have 5 on my desk. I
    have these 5 ALL IN ARMS REACH. I use them ONLY for the various burs.
    One peg board for 156c (under-cutting) 77b cup burs) another two
    boards for round burs all in sequential order. Actually all the
    boards contain burs all in order of size, from largest to the
    minuscule e.g. #031 => #003. Another peg-board is used for only
    pumice wheels and paper "Medium"disks of various wears...(new and
    almost new!). Finally, the last is for whatevers, wire wheels and
    stuff that should not be left of the desk..:>) Hope that this is a
    help. Gerry!


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________