[Jewelry making - Article 00546] - [Orchid] Ring sizes in MM on a strip for measuring correct ring sizes.

[Bill Bates]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    I had a request for a ring and the person didn,t have the ring size.
    I suggested to go to a Jeweler and get the correct size. What I would
    like to find lut is this? Is there a flat layout for M.M. ring sizes
    from 4 to 15 Any info on this would be greatily appreciated. Billy S.
    Bates royalminiatures.com If there is a gage in the flat 
    pattern I could e-mail the gage to the customer.


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________