[Jewelry making - Article 00344] - [Orchid] Enerpac Pump and Hydraulic Press

[m frison]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


Greetings,

    Has any one out their in Orchidland made their own Hydraulic Press
    as per the directions in Susan Kinglsey's Book, "Hydraulic Die
    Forming for Jewelers and Metalsmiths". 

    I would like any helpful tips available before I make the attempt. 

    I can't seem to locate the Enerpac Pump and Cylinder set as
    recommended on pg.88 of her book. Does anyone know of the new item
    numbers for this, or an alternative pump with a gauge that would also
    work well? (I have contacted Enerpac and am waiting for a reply) 

Thanks!
Margaret


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________