The Gem and Jewelry World's foremost Resource on The Internet.
Re: [Orchid] Using arrow heads in jewellery  
  [Thread Prev] [Message Prev]      [Date Index]   [Thread Index]      [Message Next] [Thread Next]
From: Byzantia
Date: Sun Feb 08 12:37:31 2004
 
     
========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Alternately: 

    1. Roll out a thin piece of modeling clay, push the arrowhead
    gently, (level) into the clay until the lowest point almost touches
    the table surface. Level the arrowhead. 

    2.Trim away the excess clay around the edges so the arrowhead sits
    level on a thin, arrowhead shaped pad. 

    3. Fit the bezel around the level arrowhead. 

    4. Solder the bezel as per the usual....you did remove it from the
    arrowhead first...right?...lol 

    5. Recheck fitting around arrowhead after soldering bezel. 

    6. Solder the bezel to the belt buckle and finish. 

    7. Clean the clay from the arrowhead. 

    8. Now do it the old fashioned Native American way...fill in the
    bezel with fine sawdust.  Fit in the arowhead level, removing excess
    sawdust as needed, compacting as you go, and set as usual. Careful
    around those edges. 

    Can't tell you how many old pieces I have fixed that used sawdust as
    a backing. It cushioned the delicate unstablized turquoise, made
    smaller stones look thicker to match other stones around it, filled
    in under uneven stones, etc....every time I open up a bezel and find
    that, I crack up. Pretty ingenious. oh...in case you were wondering,
    ninety percent of the time, I was opening up the bezel because
    someone squeezed in their bracelet one too many times and cracked
    the siver, or broke the shank of the ring for some reason. Almost
    never because of a stone problem. Good luck... 

    Lisa, (Off to Philly and ACC, just when the weather is getting nice 
    around here...figures...sigh) Topanga, CA USA



____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________


  Click to Visit  
     
  Navigate:  
   
  Orchid Resources:  
   Join & Post
 Invite a friend to join Orchid
 F.A.Q
 Galleries
 BenchExchange
 Orchid Blogs
 Orchid Message Archives [Subject Index] [Date Index]

Ganoksin now offers a number of ways for you to stay on top of the latest from Orchid!

  1. My Yahoo - Do you have a My Yahoo page? If so, you can easily read the latest Orchid posts on your personalized page by adding this feed:Add Orchid to My Yahoo!
  2. Add Orchid to myGoogle Add to my Google
  3. Read Orchid with NewsGator and Microsoft Outlook Add Orchid to Your  NewsGator
Support Orchid! - If you believe in what we're doing, you can help!

 
     
     

© Copyright 1996 - 2009, The Ganoksin Project