[Jewelry making - Article 00105] - Re: [Orchid] Fire Glazing

[Alma Rands]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    One of the problems with wet packing or using klyr-fire is that it
    often results in an uneven surface  requiring stoning.   this holds
    true whether one is  torch firing or firing in a kiln. I prefer dry
    dusting of the enamels, However, with complicated  designs this is is
    not always feasible, On those occasions when I do use wet packing, I
    apply the enamel in very very thin layers, making successive
    applications  as necessary. Torch firing is  usually done with the
    flame underneath the piece. However, bringing it to the surface of
    the piece does introduce some interesting iridescent effects.
    However, all of this is rather unpredictable depending on the enamel
    being used, and  the proximity of the flame to the piece being
    fired. Perhaps some other enamelists may be able to offer more
    suggestions. 

 Good luck. Alma


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________