[Jewelry making - Article 00059] - Re: [Orchid] Ultrasonic milling

[Neil George]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Jason, The technology has been around for quite some time, and there
    was a discussion regarding the application back in 2001. I will direct
    you to the archives where I supplied a brief outline regarding the
    Sonic Mill, and also the relevant contact information supplied by
    Ken Kotoski of MPG Repair. 

    http://www.ganoksin.com/orchid/archive/200101/msg00729.htm 

    http://www.ganoksin.com/orchid/archive/200101/msg00767.htm 

    If you need more help on the subject, give me a call. If you would
    like to chat about your application, I will be more than willing to
    assist you. Best Regards. 

Neil George
954-572-5829


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________