[Jewelry making - Article 00286] - Re: [Orchid] Bench and Shop layout

[Mark Shneyer]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    I just took a look at this thread and must comment on this last
    mention about covering up tiles and going over them with plywood and
    then new tiles. What causes a tile floor to crack is not the tiles
    being defective but a poor sub floor underneath.  To break up an old
    floor is not as daunting a task as you might think. Once the old
    floor is up you can pour a masonry sub floor (like a thin layer of
    smooth cement) to smooth out the rough spots or lay a fresh sub floor
    down on top to put the new tiles on.  You will get much better wear
    if the sub floor is done well. Mark 

   Ps Stanley, you should find a new contractor.


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________