[Jewelry making - Article 00100] - Re: [Orchid] Wax Injection unfilling

[Daniel Ballard]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Talc powder works to keep the air cut vents open enough to let the
    air out ahead of the incoming wax. This is only one possible factor
    for the wax not filling-Small adjustments in wax type or temperature
    or pressure can help. Or you may be gripping the mold too tightly for
    this particular item. 

Daniel Ballard


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________