[Jewelry making - Article 00092] - Re: [Orchid] Silver wire inlay in ebony

[david piccoli]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    I used to carve for patricia von musulin,nyc, and that was one of
    her shticks,,,, we would carve the ebony drill holes insert rods,
    with some cyanacrylate, or epoxy,, of course lightly sanded,, then
    recarve,, actually finish,,, can't get too hot, or they come
    out(polishing heat, sanding heat),,, upgrades--- glue that can take
    heat,, thread the rod as was expressed by someone else, pressfit
    rods,,, btw, i have seen silver in some lighter woods(lignum vitae
    included), and it is suprisingly, extremely beautiful, dp 


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________