[Jewelry making - Article 00036] - Re: [Orchid] CNC Cutting

[Neil George]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Mike, The answer to your question is yes. I would be more than happy
    to do so, therefore start dialing :-) Usually here 7 days a week from
    6am till around 8pm. However, best time to call is after 10am,
    because usually by then, all of the machines are setup and running.
    Prefer phone, because that means I can walk around and monitor the
    machines whilst I am talking :-) 

Best Regards
Neil George
954-572-5829


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________