[Jewelry making - Article 01278] - Re: [Orchid] Vulcanized VS. RTV

[nardon lopez]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Dear Ken; I have too, a lot of molds of Castaldo goldlabel and i make
    it for a large production of pieces in gold and silver.i  have used
    no shrink-pink ,and a silicone from a company of my country. when i
    want a o% shrinkage i used too RTV but ONLY works well in little
    number of pieces but for this cases is the solution.in this moment i
    find the rubber of my dreams,this rubber works very well and the
    cost is less than the castaldo rubber and i have a very fine cut
    with my x-knife and very good priable,this rubber is the rubber from
    "ZERO D-PRODUCTS"(www.zerodproducts.com) and they have too a very
    good silicone,i'm very happy with this,in this moment is the only
    rubber that i cut.I think too that for a large production the rubber
    is the better solution.thanks for your coments.


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________