[Jewelry making - Article 00767] - Re: [Orchid] CNC Mill Preference

[Charles Bahringer]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Richard, There are many good mills out there, I use the Wolverine 3
    from Align- Rite (www.alignritetool.com ask for Matt Dunn) after
    months of shopping and comparing quality and price.  Gem Vision
    offers one "The Revo" that is excellent ( www.gemvision.com ) that I
    would have considered if it was a available two years ago.  Someone
    mentioned the Model Master mill, my opinion is that is a very
    expensive toy compared to other higher quality mills out there plus
    MM customer service is the worst I've ever experienced.  Just my
    opinion. Charles 




____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________