[Jewelry making - Article 00741] - Re: [Orchid] Dumb rolling mill question

[Ken]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Just my .02 before we beat this to death. I have a sponge wired on
    the top and bottom of the mill to where the rollers make contact. The
    sponge is saturated with light motor oil. Seems to keep the rollers
    coated well and wipes away any dirt or debris when in use. I use the
    mill almost daily so dunno about long term storage, but I do know its
    no fun sanding rust off the pins. 

Regards,
Ken


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________