[Jewelry making - Article 00730] - Re: [Orchid] Rolling Mill Decisions

[Jeffrey Everett]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========



>     Dear Jeffrey, You have a really good question. If I remember the
>     explanation given to me a lot of years ago it has to do with contact
>     area and approach angle to the roll. <snip...>

    Wow, thanks for a great explanation Eddie. I have seen 4 high
    rollers, but it's been so many years I had forgotten. Your
    explanation make perfect sense to me, and I appreciate the time you
    took in answering! 

    By the way, back at the 1985 CA MJSA show you talked me into joining
    the MJSA. I haven't seen you since, but maybe we'll meet again
    someday, and it will be my pleasure. 

Jeffrey Everett


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________