[Jewelry making - Article 00178] - Re: [Orchid] Jump ringer systems

[raygro]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Spider, Sounds like you either have a dull blade or the blade is not
    centered in the guard/guide. The milled out section of the coil
    holder's top plate must also be facing downward contacting the coil
    for maximum depth of cut. I suggest you also collapse the coil on a
    wooden dowel like a Slinky. The dowel will support the coil during
    the cutting operation. How are you feeling? Ray  


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________