[Jewelry making - Article 00113] - [Orchid] Arc welders

[LSHancock]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    I have the honor of using a buddies laser welder whenever I need it,
    unfortunately I have to drive through the worst traffic to get
    there.  I have been drooling over the new tack welders, especially
    since they have been featured in many of the magazines I have read
    (Bench and Professional Jeweler).  Has anyone here on the forum
    actually used one?  How do they rate in comparison to a laser?  I am
    sure they won't be as versatile as a laser since I haven't heard
    that they can do anything about pits, but I don't use them for that
    anyway.  I'm thinking about getting one this winter, either at
    Tucson or at the MJSA show if I can wait that long.  I'd be
    appreciative of any advice or comment that comes my way. 

Larry
(Anyone near NC have one that I could come see in action?) 


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________