[Jewelry making - Article 00071] - Re: [Orchid] Jump ringer systems

[raygro]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Jan, The standard and long (high production) Jump Ringers will cut
    from 30 to 12 guage wire. Straight round mandrels up to 1/2" may be
    wound on the standard winder. We also produce a set of mandrels in
    finger sizes from 2 through 12. (Approx. 5/8" to 7/8"). The mandrels
    above 1/2" have their ends turned down to fit the 1/2" capacity
    chuck. These coils may also be cut without additional accessories.
    Hope this helps. Ray 



____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________