[Jewelry making - Article 00072] - Re: [Orchid] Casting sheet silver

[Alma Rands]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    This is more a question than an answer to the problem of casting
    sheet silver, but could one make a mould out of investment, dry it in
    the oven or kiln, and then pour silver into it ?? If it worked it
    would would give a nice smooth surface which one could carve or just
    let be. Just wondering. 

Alma 


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________