[Jewelry making - Article 00818] - Re: [Orchid] Tumbling and Satin Finishes

[Richard Hart]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Hello All, The best satin finish I have gotten is to go through to
    stainless steel shot polishing, and then put back in the plastic or
    ceramic media. The finish is different, and looks a whole lot better
    to me.Richard in Denver 

    P.S. Computer problems made it impossible to respond to those of you
    that reponded about a Denver Orchid dinner during our Sept. show. I
    am sure you all found that the show can consume all your time. I do
    apologize for not getting back to you. My computer has recovered. It
    was a gruesome week. 



____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________