[Jewelry making - Article 00664] - [Orchid] [Setting tips] Repairing High Speed Setting burs

[Gerald]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    You've got a client outside your shop waiting for you to set her
    stone and the only bur for you to use is almost thread bare of
    teeth. Help! Get out your separating disk, or as its commonly known
    as a "carborundum" wheel. Carefully allow the wheel to ONLY grind
    away at the teeth at the widest point of the old bur, one at a time.
    Grinding away and at the same angle, so carefully as to allow the
    worn teeth to be redefined and return to their original purpose.
    "Sharp as nails!" 

Gerry, the Cyber-Setter
gemz AT ican.net 
toll free cell phone 1-877-850-0003. 
http://www.gemzdiamondsetting.com


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________