[Jewelry making - Article 00621] - Re: [Orchid] Repairing molded wax

[frank goss]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Stan, check out Disclosing Wax  at Gesswein product # 261-6360  it
    is designed to be applied with fingertips and smooth over defects
    and then burnish back to fill voids and detect high spots. You can
    also heat glaze the surface of the waxes to make voids appear and
    also to fill them, but this takes a practiced touch. It is the
    technique I use and I use a hot air torch designed for the
    electronic industry that runs off butane.  Frank Goss


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________