[Jewelry making - Article 00065] - [Orchid] Wax carving problem

[W Denayer]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Hello, I would like to ask a question. We have been talking about
    this before and while the diagnosis is clear I still do not know how
    to remedy the problem. How can I prevent holes (not porosity, but
    holes due to investment creeping in the seam) at the place where I
    weld a bezel to the rest of the ring? I have done this several times
    by now, taking great care to have closed seams between the
    components, but the problem continues to persist. Does someone has an
    idea? Thank you for reading. Best, Will 



____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________