[Jewelry making - Article 00029] - [Orchid] Comments about Gemvision's Revo Mill

[Kevin Fertenbaugh]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


Hi Everyone,

    Just purchased Gemvision Matrix software.  Looking forward to using
    it.  I would like to know if anyone out there has purchased the REVO
    mill from Gemvision?  If you have, could you tell me how you like it
    so far. 

Thank You,

Kevin Fertenbaugh

Hasko Jewelers
www.haskojewelers.com
kevin AT haskojewelers.com



____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________