[Jewelry making - Article 01077] - [Orchid] Perforated ceramic block trick

[jesse brennan]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    To clamp parts to  one of the perforated hard surface blocks make
    bunch of little clips of Nichrome or stainless  steel wire. " L"
    shaped    about 1/2 " on the short arm and 1" on the long arm   bent
    so the angle is a bit less than 90 degrees. Place short arm in hole.
    The long arm will hold work in place on the block . Use as many as
    you need-- an oxidized surface keeps solder from sticking. They work
    until lost. jesse 



____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________