[Jewelry making - Article 00997] - Re: [Orchid] Setting up a metal mold - CNC

[PrecisionHawaii]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Aloha, Long time no hear. You need to set up a pin or dowel pin
    master for the mold and subtract the model. If you need help or want
    to do it on list to help others its ok with me. I know you are using
    ArtCAM so, I can help. But others using other 3D design software, may
    also benefit. If you want contact me of list, thats ok too. 

    Best regards, Christian Christian Grunewald Precision Modelmaking
    Technologies Hawaii (808) 622-9005 Christian AT 3Dclipart.net 
    ChristianG AT WylandGalleries.com


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________