[Jewelry making - Article 00973] - [Orchid] Setting up a metal mold - CNC

[BH]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    I have a question for any of you CNC guys out there - Just how do you
    set up a two part metal mold to ensure proper alignment when 
    injecting the pattern material?  I have my own method, which seems a
    bit hit-and-miss, so I would like to hear from someone doing this on
    a regular basis. 

    A direct off list response might be best since this topic may
    involve some back and forth emails which may be of no interest to the
    majority of Orchid subscribers. 

Thanks, Aufin01 AT comcast.net


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________