[Jewelry making - Article 00454] - [Orchid] Plating Racks

[Joe Sepe]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    We have electroform plating racks with threaded post & PVC nuts with
    rubber sealing washers. The washers are worn out & need to be
    replaced however the rubber I have tried so far the plte migrates
    onto the washer & has to be picked off after 1 rack. Any ideas on
    what kind of material could be used for this purpose wuld be helpful. 

    Joseph Sepe Manufacturing Manager Carla Corporation 33 Sutton Ave East
    Providence R.I. 02914 Phone(401)438-7070 Fax (401)438-0455 
    JSepe AT carlacorp.com


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________