[Jewelry making - Article 00079] - Re: [Orchid] Retrofitted a motor to a rolling mill?

[frank goss]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Yes; I had this done several years ago. The man who did it for me
    used a cleveland reducer to lower the rotation rate of a 1/2 hp
    motor and couplings found in basic equipment supply catalogs. I
    still have this system although I have not used it in years. If you
    are interested I would be willing to sell it. It is very heavy and
    you will nedd a 2 hp motor to really get the power for rolling. If
    interested contact me at 713-861-0706 and we can talk. I am located
    in Houston Tx. Frank Goss 



____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________