[Jewelry making - Article 00024] - Re: [Orchid] Rolling Mill

[Dubiel Design Studio]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Hi Jena, Difference will be felt in the amount of force required to
    roll out the metal. I have a Durston mill without the gear
    reduction. You need the strength of Samson to roll out sheet and
    have to do so in very small increments. I have also used a machine
    with gear reduction at the community college - much easier!. 

    I was in touch with Durston in the UK to see if my machine could be
    retrofit with a gear reduction system. They quoted me 135 pounds
    sterling (or approx. $224 USD). 

    I'd recommend you invest in the extra $100 now. 

Regards
Richard Dubiel
ddstudio AT rogers.com



____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________