[Jewelry making - Article 00228] - Re: [Orchid] Bronze casters

[Martin Niemeijer]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Hello Pete, I have a good relation with a bronze, brass aluminum
    casting firm. They do sand casting or casting in coquille. Very
    cheep. However the desired thickness of 2 mm is at the edge. 3-4 mm
    would be better. Are you doing this by cost reasons? If you send me
    a picture I can make an offer, how much it would cost here. 

    Greetings Martin Niemeijer 

Ndesign
Molenkreek 23
8032 JK Zwolle
The Netherlands
Phone +31 (0)38 4539203
Mobile phone +31 (0)651832576



____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________