[Jewelry making - Article 01212] - Re: [Orchid] CNC cutting two parts metal mold

[Nikitas Pitsillides]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Dear friend, to make this simple male and female mould you must
    check and calculate only two thinks: a. The offset of your tool
    (cutter Diameter),tip radius,side angle, flat radius is not important
    for 2d mould. b. If you have angles in your male mould you must
    calculate and redesign them according the tool diameter some
    programs(Artcam etc) calculate those parameters automatically 

Greetings from the island of Venus (CYPRUS)
Nikitas


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________