[Jewelry making - Article 00922] - Re: [Orchid] Laser welder

[ringdoc]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    thanks so much for a very informative note on tipping with the laser
    welder, could you tell me about how you anneal "I sometimes lightly
    anneal the tips after building them up with the laser, since 
    sometimes laser welds are a bit too brittle for safety." 

    I am with you on silver heating up, I had a small container of water
    to quench the braclet I was working on and the water turned to
    steam!!! and splattered on me...ouch! we have the same model, 125
    jules and we get argon this week, our local supplier had to order
    the 4-9's, might look into hooking up air, what do you have for a 
    compressor??? or do you use a tank?? RIck


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________