[Jewelry making - Article 00834] - Re: [Orchid] The Tool I Wish I Had

[SSJewelry9]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Hi Nancy, Yes there is a tool to cut solder snippets. I do not know
    if this is the proper name but I was told it is a nibbler. I think
    it is used in sheet metal work. I cut narrow strips of solder with
    mine. I can make the strip really short or up to 1/4 inch long. The
    depth is about 1/16 inch. If you want narrower just do not bite as
    deep. The snippets are flat. My tool says Adel Tool CO, Chicago,
    Ill., For soft material only, not over 18 Ga. If you want any more
    info or a PIC just ask. John Daly Grand Junction, CO


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________