[Jewelry making - Article 00756] - Re: [Orchid] Question about kilns

[C L Syrek]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Hi Robin- I just purchased a Vcella kiln #15 (I believe that was the
    model #) I will be using it for exactly what you describe except for
    the burnout part. I chose it because it was the only front loader
    that would go up to 2300 F and was not going to become a MAJOR piece
    of furniture in my house. It has a 15x15x11 interior so I will have
    plenty of space to enamel, fire small scale ceramics as well as
    annealing beads. 

    THe Vcellas come in a huge range of interior/exterior sizes. 

    www.vcella.com 

Hope this helps.
Carree



____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________