[Jewelry making - Article 00733] - Re: [Orchid] Benches height

[julieta Odio]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Seat height depends on YOUR hetght, actually the best posture is
    obtained when you can lay your feet flat on the floor and your knees
    make a right angle. As for the work bench it is better to make you
    hunch the least possible. Remember that you have to work up close to
    very small things for a long time so it is better that your work
    bench be a little higher to make this a comfortable position to be
    in for a long time. I could give you some measurements but actually
    as I said before it should be differrent for each individual. 

Julieta Odio Bernardi
Designer/Metalsmith


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________