[Jewelry making - Article 00719] - [Orchid] Rolling Mill

[Nanvhelmer]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Hope you guys can help. I just purchased a rolling mill, much to my
    delight and would appreciate advice on how to mount it. Currently,
    my "work bench" is a folding table from the local office supply
    store. Is this stable enough for the mill?  if not, I was thinking
    of purchasing a wooden workbench kit from Home Depot. Your thoughts
    and opinions are greatly appreciated. Nancy 

    In Texas where it's raining and temperatures of 40 to 75 degrees.


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________