[Jewelry making - Article 00413] - Re: [Orchid] Benches - to cutout or not to cutout

[Suzy3D]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Like Karen Goeller, I strongly prefer a separate soldering area. Not
    only do I have to move around more, but I like an immaculate
    soldering area, and tend to have a messy bench. I've been known to
    set the bench on fire when soldering at it, so a non-wooden
    soldering area is safer. 

    I also like to work at a height about halfway between table high and
    normal bench high. That way, I can look down on a piece and get a
    better view without standing up over and over. 

Karen Hemmerle


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________