[Jewelry making - Article 00372] - Re: [Orchid] Engraving Problem

[marco mandragon]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Hi John  Thank you for your advice.I still havesome questions.When
    you wrote: "I prefer a square graver with a heel cut at the corner to
    10 degrees." were you talking about to grind the lower twoface
    configuration of the square belly to a 10 degree curvature without
    affecting the original square shape of the graver? this is easily
    achieved on a flat graver cause it has a single flat belly, Can you
    please be more specific how to do this and what size of square graver
    is necessary? Sorry, All this questions Might sound stupid but I am a
    beginner learning by 
    myself.  Marco


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________