[Jewelry making - Article 00341] - Re: [Orchid] Engraving problem

[M. Clodius]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Hello , You can *fake* diamond cut by using a  bur  45  , 70 or 90
    degree depending on the look you want . Lower the bur to your
    surface making a stationary cut , dress the cut with a shaped
    silicon wheel to fit  then polish well with shaped felt bur . You
    can get a look  80% or so as bright as diamond cut , works OK on
    repair work . 

Mark Clodius
Clodius&Co. Jewelers

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________