[Jewelry making - Article 00285] - Re: [Orchid] Tools I'd like to see

[Martin Niemeijer]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Hello Mark I solve this burr problem by etching the burs A few minute
    is my file etching solution and you have burrs 0.1 mm smaller in
    diameter use old ones for it and you save also direct money 

    Clean the file in a hot washing soda bath with a brush, or with an
    other way of decreasing. 

	Than put them in the following mixture:
	7 parts water
	3 parts sulphuric acid
	1 part Nitric acid.

    In a few minutes ready. 

    Neutralize in washing soda again. 

Greetings
Martin Niemeijer

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________