[Jewelry making - Article 00212] - Re: [Orchid] Mold cutting

[frank goss]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    I have to agree with Peter here. I tried one of the mold cutting
    tools and found that it just is not as efficient or a versatile as a
    good old can opener. I personally use the end of a rat tail file that
    has been bent at a 90degree angle and sharpened. I just clamp it in
    my bench vise and set the best angle to cut the mold. In defense of
    the afore-mentioned mold cutting tool I did find it to be less stress
    on the hands. For those without a lot of hand strength that find
    holding the molds open while cutting a difficult and cramping process
    the mold holder may be the way to go. Not for me. I gave mine away.
    Frank Goss 


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________