[Jewelry making - Article 00938] - Re: [Orchid] Pipe-Cut Gold Rings

[Cynthia Eid]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Dan, another source for these ring blanks would be to use cut off
    sections of deep drawn tubing.  This is exactly what some of the new
    Bonny Doon deep draw tools are made for.  The tools can be made for
    whatever gauge and size tube you want. 

    I would suggest that you post your request on the Discussion Group
    at Bonny Doon Engineering.  The URL for the discussion group is
    http://www.bonnydoonengineering.com/ceilidh/ceilidh.html I think that
    someone with a hydraulic press and deep draw tools might do the
    blanks for you.  You might like to have the ring tube made, and then
    cut off sections as you decide what width you want.  (Or, if you have
    need for lots of these, you might decide to invest in the tools for
    yourself!) Cindy www.cynthiaeid.com

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________