[Jewelry making - Article 00871] - [Orchid] Re: [Source] Pipe cut gole rings

[WADEDESIGNS]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    To Dan Statman I just purchased 14k gold tubing with a 2.0 mm wall
    and an inside diameter of 15.5 mm, thats about a 5 finger size. I
    got it from Stern and Leach. They can make it in most any dimesion
    you could want. Nice people but be aware that they have a 100 dwt.
    minimum for gold and a 100 oz. minimum for silver. I saw it off in
    tapered widths and hammer it up to the size that I want. It's very
    nice for hand engraving! 

John Wade, WADEDESIGNS AT aol.com

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________