[Jewelry making - Article 00861] - [Orchid] See through RTV

[Alan]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Just wondering which is the best choice in "see through" RTV rubber
    at the moment.  I'm presently using vulcanising rubber but wondering
    if the latest advances have helped improve the mould making and
    cutting process, to a point which compares favourably if not
    exceeding that of the vulcanising process. 

    I would also be interested in any UK supplier of recommended
    products please. 

Regards
Alan Lewis

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________