[Jewelry making - Article 00766] - [Orchid] [Source] Pipe-Cut Gold Rings

[Dan Statman]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    I am in need of some gold ring blanks.  Here are the specific
    dimensions: Straight Pipe style bands with flat inside and outside
    profiles.  I would like to be able to select a range of ring widths
    from 5 to 8 mm.  I would also like a minimum thickness (inside to
    outside) of 2.0mm.  These can be unfinished pieces as I will be doing
    extensive manipulations and refinishing of the final designs. 14K
    and/or 18K (possibly platinum, but later on that) Thank you for any
    and all help. 

Daniel J. Statman, Statman Designs
www.statmandesigns.com
dan.statman AT rennlist.com


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________